If you own a boat maintenance business you may have considered what your charges should be and what the boat owners are willing to pay. Here are some thoughts on the type of charges and services you should consider. Basic Services You Can Offer: Outboards 1-25 Hp $ 40.00, Above 25 Hp $75.00 Change Gear Oil Add Fuel Stabilizer Start, Run and Fog Engine Grease Fittings Drain Fuel System Spray Power Head with WD-40 Inboards $60.00-100.00 Single Engine, $100.00-150.00 for Twins Oil Change Change Gear Oil Add Fuel Stabilizer Start, Run and Fog Engine(s) Drain Block and Manifolds, Fill with Non-Toxic Anti-Freeze Grease All Fittings Disconnect Battery Check All Systems Sprinkle Rock Salt Near Bilge Drain Plugs Wipe Down Engine(s) with WD-40 Acid Wash Bottom (Out of Water): $50.00 to $75.00 for small boats up to 22 feet $75.00 to $$100.00 for 22 to 27 foot boats $100.00 to $125.00 for 28 to 33 foot boats Additional Winterization (at a per hour fee): $55.00 per hour Some Franchisees Charge Simply by the Foot: $14.00-17.00 per foot It is important to pay special attention to: Bilge pump Batteries Sanitation system Fresh water tanks Main engines and generators Canvas covers Docking lines Power cords Deck gear Fuel tanks Cabin Sailing yachts Sail covers Roller furling gear Deck hardware Dock box (give it a wash or shine it up before you go, customers will love it) Bilge Pumps: Check the operation of all your automatic bilge pumps. Trip the float switches by hand or better yet flush out the bilge with fresh water. This will also get rid of any stagnant water. Then after pumping out as much water as possible pour one to three cups of chlorine in to keep long standing water from smelling. If the boat doesn't have automatic bilge pumps, suggest to the owner that they be installed and refer the work to a professional. Batteries: Check fluid levels. Remember fully charged batteries will not freeze. Top them off and remember to protect your eyes from splashing. Use terminal cleaner or a wire brush and coat with an anti-corrosive compound. Petroleum jelly prevents rust. Another option is for the boat owner to take them home, in this case advise him to trickle charge them every 30-60 days. Sanitation System: Pump out and rinse holding tanks three times. After cleaning add holding tank blue treatment chemical to eliminate odors. Close the head discharge, through-hull ball valve and raw water supply valve. Pour a small amount of chlorine bleach into any standing sea water in the head itself to eliminate the formation of bacterial growth and odor. Add a little anti-freeze such as Starbrite 'Bio-Safe' Anti-Freeze and pump it through hoses, holding tank, Y-valve, macerator and discharge hose. Check owner's manual to make sure there are no other parts which need tending to. Make sure to check and see if your anti-freeze is alcohol based because it will not damage the system. Water Heaters: Put some non-toxic anti-freeze into the heater and make sure assembly and plumbing is surely fastened and secure. Through Hull Openings: With a screwdriver or similar tool, poke up inside each opening. Make sure there is no marine growth left on the inside. Fresh Water Tanks: Pump them dry and add some bleach and non-toxic anti-freeze to the system. Always use Propylene Gycol anti-freeze and not engine type anti-freeze. Refill and pump them dry again. Be sure to turn off the pressure pump. Isolate hot water by disconnecting the in and out lines. Some do not make noise when the fresh water tanks are empty. Make sure to also check faucets, sinks, shower stall drains, etc. |
About Us
